1, The ice machine should be installed away from heat, no direct sunlight, good ventilation, the ambient temperature should not exceed 35 degrees Celsius, in order to prevent the ambient temperature is too high lead to poor condenser heat, affecting the ice effect. The floor of the ice machine to be installed should be solid and flat, and the ice machine must be level, otherwise it will cause no ice and noise during operation.
2, Ice machine back and left and right side of the gap is not less than 30cm, the top of the gap is not less than 60cm.
3, Ice machine should use an independent power supply, green power supply and with fuses and leakage protection switch, but also to a reliable grounding.
4, Ice machine water to meet national drinking water standards, and install water filtration device, filter impurities in the water, so as not to plug the water pipe, contaminated sink and ice mold. And affect the ice making performance.
5, When cleaning the ice machine should turn off the power, it is forbidden to use water pipes directly at the body flushing, neutral detergent scrub, non-acidic, alkaline and other corrosive solvents.
6, Ice maker must unscrew the inlet pipe hose head for two months, cleaning the inlet valve filter to prevent impurities in the water blockage plugged into the inlet, which led to a smaller amount of water, resulting in no ice.
7, The Ice machine must clean the condenser surface dust every two months, condensing poor heat will cause compressor parts damage. Cleaning, the use of vacuum cleaners, small brush cleaning condensate surface oil, can not use sharp metal tools to clean, so as not to damage the condenser.
8, Ice machine water pipes, sinks, storage tanks and protective film to be cleaned once every two months.
9, Ice machine does not use, should be cleaned, and use a hair dryer to dry ice mold and the water inside the box, placed in a non-corrosive gas and dry place to avoid open storage.